Hinged Door - H003

Hinged door mainly includes four parts as below:
Steel structure
Middle and surrounding frame is mainly built up by No.10 channel steels which are welded together. Appropriate measure will be taken to control the welding deformation of steel structure and ensure the size precision and flatness.
Decoration coating
Steel structure will be covered with PVDF painting. Anti-corrosion processing will be the same with that applied on the steel structure.
Outer steel sheet will be 4mm thick steel sheet with good rigidity. The outer steel sheet will be connected with the steel structure by plug welding.
Sealing system
Top and bottom sealing and the sealing between the door panels shall be made from fiber reinforced EPDM which are free from crack and breach due to long time folding.
Control system
Main control parts include local switch box, loop coil, and photo sensors. Logic control is made by PLC. Export driving parts include frequency inverter, motor and hydraulic driving system.
Supervisory control panel and control board could be installed in a remote control room. Driving power, controller, frequency inverter, mode selection switch (auto/manual), operation switch (open, close, stop), and interlock switch to each door are included in the control panel. Through the panel the operator could select between auto/manual modes, control each door, receive the status signal of each door, and indicate the current situation of each door (door failure, obstacle, loop coil failure, etc.).
Function selection switch (local/auto/control room) is included in local control panel. When “control room” is selected, door operating include open, close and stop will be controlled from control room.

Other options
Daylighting windows could be arranged upon request.
Personnel door could be arranged upon request.
Remote control function from overhead crane operator could also be satisfied upon request.

Parameters of hinged door and driving system

Name Hinged door and driving system
Type Hinged door, 2 leaves
Location Indoor
Qty 8 Sets
Clear opening Height 6000 mm
Width 5000 mm
Main mtl Carbon steel
Door panel 5.0mm
Time period Open ＜ 15 sec
Close ＜ 15 sec
Operation
Could be controlled locally/from control room/from overhead crane operator
Self-control Embedded loop coil and infrared sensor
Driving Type Hydraulic
Qty 8 sets (one for each door)
Speed ≥ 50 mm/sec
Motor Type F grade insulation
Temperature rising: grade B
Power 380 V，50 Hz
Start-up Frequency convertible, voltage convertible