JUKI KE-2080 SMT part - AI Part

2
Enter the pattern library name.
3
Click [OK].
. The data are registered in the pattern library.
1E3C-E-PMB01-A02-00 Page 1-39 1.5 Creating the Production Data
1.5.10 Print Position Data
1. About the print position data
1. Print position data When the board of the specified size is printed at the center of the specified mask plate-making reference, (0, 0, 0) point of the print position data agrees. (However, the origin of the machine might deviate a little.)
. If there is an error in the mask plate-making or if you use a mask frame that is not specified by us, the (0, 0, 0) point of the print position data may change.

2. Print position offset This is used if the positional deviation occurs because of the difference of the squeegee-print direction or if a subtle deviation occurs because of an expansion of the mask in spite of the mask recognition. Normally, set it to “0.” And, when the position-correcting flag of the solder recognition function is “ON,” or when the position correcting feature is used in solder inspection, the dislocation detected by the print status check in the machine adjustment is input in this offset as correction values.
2. Editing the print position data Normally, this data does not need to be edited because it will be adjusted to the value found by the production data teaching.
Page 1-40 1E3C-E-PMB01-A02-00 1.5 Creating the Production Data
1.5.11 Data Check
1. About the data check
This is used to check that all the data in the program is valid.
2. Executing the data check . Normal case
1. Click [DataCheck].
. The window opens.
. This step uses the screen of SP80V for description.